Boss Audio Systems RC-2 - Manual (Page 15)

15
Creating Loop Phrases by Recording Guitar or Bass Performances
* Recording or overdubbing may stop before you are finished if
the RC-2’s memory runs out. If this occurs, delete any
unnecessary phrases (p. 33) and try the operation again.
6. When you are finished with playback or
overdubbing, press the pedal twice.
* Be sure to press the pedal two times within an interval of one
second.
7. To save the recorded phrase, use the fol-
lowing procedure.
1) Set the MODE knob to WRITE.
2) Press the SELECT/ENTER button.
The indicator flashes in yellow.
To save the data to a phrase track other than the one
currently selected, use the PHRASE SELECT knob
to choose the desired save destination.
To cancel the save procedure, switch the MODE
knob to a setting other than WRITE while the indi-
cator is still flashing.
3) Press the SELECT/ENTER button.
When the save is complete, the indicator light flash-
es at the same rate as the tempo.
* For more details on saving, refer to “Saving Phrases
(WRITE)” (p. 32).
Undoing Overdubs (UNDO/REDO)
The RC-2’s Undo function allows you to cancel the most re-
cent overdub operation. This is convenient if you make a
mistake during overdubbing. If desired, you can restore the
cancelled overdub with the Redo function.
To cancel ( undo ) the most recently recorded overdub, hold
down the pedal for at least two seconds.
When you undo an overdub, the REC/PLAY/DUB indica-
tor flashes rapidly in yellow.
* With overdubbed phrases, hold down the pedal for at least
two seconds during recording or overdubbing to carry out
the undo.
If the phrase has not been overdubbed, holding the pedal down
for two seconds or longer during playback or overdubbing
deletes the phrase in the temporary memory (p. 31).
* You cannot use undo if the RC-2 has only a small amount of
memory left. (In this instance, the REC/PLAY/DUB
indicator won’t flash rapidly when the pedal is held down for
two seconds or more, and the undo operation won’t be
carried out.) For more information, refer to “Unable to
undo” (p. 40).
To restore ( redo ) a cancelled overdub, hold down the pedal
again for at least two seconds. When you redo an overdub,
the REC/PLAY/DUB indicator flashes rapidly.
RC-2_e.book 15 ページ ２００６年１０月２７日 金曜日 午前１０時３１分