HCO SG580MB Manual - Manual (Page 24)

HCO ScoutGuard SG580MB
4 Advanced Operations
Page 21
Minutes provided that the previous value is 1 Minute.
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Interval.
c) Press LEFT or RIGHT to decrease or increase to 5 Minutes.
d) Press OK to save the current setting and the option will be
un-highlighted.
Press MENU to cancel setting and return to info display.
4.1.11 Set PIR Sensitivity
This parameter defines the sensitivity of the PIR. There are three
parameters: High, Normal, and Low. The default value is “Normal”.
The higher degree indicates that the Camera is more easily to be
triggered by motion, taking more pictures or recording more videos. It
is recommended to use high sensitivity degree in room or environment
with little interference, and to use lower sensitivity for outdoor or
environment with lots of interference like hot wind, smoke, near
window etc. Furthermore, the sensitivity of the PIR is strongly related
to the temperature. Higher temperature leads to lower sensitivity.
Therefore it is suggested to set a higher sensitivity for high temperature
environment. It is recommended to use the “Low” setting for
temperatures below 35 degrees Fahrenheit and the “High” setting for
temperatures exceeding 95 degrees Fahrenheit.
The following shows how to set PIR sensitivity as Low provided that
the previous option is Normal.
a) Press MENU to display the setting menu.