Harrington Signal Tracker T8000 - Operation Manual - Manual (Page 17)

B
5
A
4
HSI #780-0923 FireSpy Tracker Operation Manual
13
4 Using the menu system
4.1 Accessing the menu system
To access the menu system, press the PROG key and enter the access code for the desired level. The
default code for Level 1 (maintenance functions) is 11111111. The default code for Level 2 (programming
functions) is 22222222.
The SLCs must finish their startup before the menu system can be accessed. The SLC startup takes 10-
30 seconds after the panel is reset.
4.2 Exiting the menu system
The changes you make are saved after you press ENTER on each screen. There is no extra step to save
changes before exiting the menu system. To leave the menu system at any time, press RESET ; this will
also reset the panel.
4.3 About the numbering used
Each menu in this manual is given a number based on how to navigate to it starting from the main menu:
•
A number means press the number to select an option.
•
A letter indicates which "more" screen the option is chosen from (A is the first screen, press C to get
to B, the second screen).
•
Levels are separated by periods.
So to navigate to the Level 2 Menu 1.2B from normal standby press PROG (enter the passcode for
Level 2), press 1 for child menu 1, press 2 for child menu 2, then press C to get to the second screen of
options.
4.4 Menu navigation
Display
The display shows available menu options.
Available keys
0 to 9 go to child menu corresponding to number
E go back to parent menu
RESET exit the menu system and reset the panel
Program Menu
1. Clock
2. System Options
3. RS-485 Settings
4. Input Settings
5. Output Settings
6. Point Settings
7. Group Settings
4.5 Assign a setting
Display
When a screen shows some values to change, highlight the value you
wish to change and then change it.
Available keys
C / D : highlight the value you wish to change
A / B : change the highlighted value
E go back to parent menu
ENTER go back to parent menu and save changes
RESET exit the menu system and reset the panel
Serial Port Config
Mode: PC Link
Dial Number:
Modem Init String: