ExpoImaging ExpoDisc: Nikon Custom WB - Manual (Page 4)

Copyright, 2013 ExpoImaging, Inc.
“Nikon” and the Nikon camera models listed are Trademarks of Nikon, Inc.
direction for the given lighting condition and press the shutter release button.
See the ExpoDisc Instruction Manual or Quickstart for more information on
where to aim the camera when taking your white balance reading.
6. ‘Good’ will replace ‘Pre’ in the control to indicate a successful white balance
reading.
7. If ‘no Gd’ appears, then this indicates that you need to adjust your exposure
and reattempt to set your white balance. Repeat steps 5 and 6 until you see
‘Good’ flash in the control panel.
8. Lightly press the shutter release button to exit menu functions.
9. Remove the ExpoDisc and start shooting.
Nikon D60
1. Install the ExpoDisc over the front of the cameraʼs lens.
2. Allow the camera to set an automatic exposure using the “P”, “S” or “A”
modes or set the correct manual exposure in “M” mode.
3. Press the ʻMENUʼ button.
4. Display the shooting menu and select ʻWhite Balanceʼ > Preset Manual, and
then press the multi selector right.
5. Highlight ʻMeasureʼ and press the multi selector right. The screen shown at
right will be displayed; highlight ʻYesʼ and press ʻOKʼ.
6. The message “Take photo of white or gray object filling viewfinder under
lighting for shooting” will be displayed. When the message clears from the
display, ʻPreʼ will start blinking in the viewfinder. ʻPreʼ will remain blinking for
about 10 seconds or until the shutter is tripped.
7. With ʻPreʼ blinking, aim the camera towards the light illuminating your subject.
Press the shutter release button. See the ExpoDisc Instruction Manual or
Quickstart for more information on where to aim the camera when taking your
white balance reading.
8. If the camera was able to measure a value for white balance, the message
“Data acquired” will be displayed.
9. Improper exposure will result in an error message that reads “Unable to
measure preset white balance. Please try again.” Adjust your exposure and
repeat steps 4-8 until you see the message “Data acquired”.
10. Remove the ExpoDisc and start shooting.
Nikon D80
1. Install the ExpoDisc over the front of the cameraʼs lens.
2. Allow the camera to set an automatic exposure using the “P”, “S” or “A”
modes or set the correct manual exposure in “M” mode.
3. Press and hold the ʻWBʼ button with left thumb while turning right thumb wheel