E-flite UMX Hyper Taxi BNF - Manual (Page 9)

9
EN
Bind your aircraft and transmitter before performing these tests. Move the controls on the transmitter to
make sure the aircraft control surfaces move correctly, freely, and in the proper direction.
Tip: Programming for the control surfaces has already been done in the receiver of the Hyper Taxi, so no
mixing is required in the transmitter.
To demonstrate modes 1–4, only the axis being tested is shown.
Always keep throttle at low position during testing.
Control Direction Test
Up
Elevator Down
Elevator
Left
Aileron Right
Aileron
left
Rudder Right
Rudder