E-flite UMX Hyper Taxi BNF - Manual (Page 10)

10
EN
Dual Rates and Expos
We recommend using a DSM radio capable of dual
rates and expo due to the aerobatic capabilities
of the Hyper Taxi. The settings shown here are
recommended starting settings. Adjust according to
individual preferences after initial fl ight.
If using the DX4e or DX5e transmitters, we
recommend activating Expo for smoother control.
For activation and deactivation of the Expo in the
DX4e and DX5e, see below.
NOTICE: Do not set your transmitter travel adjust
over 100%. If the TRAVEL ADJUST is set over
100%, it will not result in more control movement, it
will overdrive the servo and cause damage.
It is normal for linear servos to make signifi cant
noise. The noise is not an indication of a
faulty servo. Tip: For the fi rst few fl ights, fl y the model on
low rate.
Dual Rates
High Rate Low Rate
Aileron 100% 65%
Elevator 100% 70%
Rudder 100% 70%
Expos
High Rate Low Rate
Aileron 25% 10%
Elevator 25% 10%
Rudder 25% 10%
DX4e
(Modes 1 and 2)
Activate and Deactivate Expo
1. Put the ACT switch in the down position
(ON) and the Rate switch in the down
position (LO).
2. Push and hold the trainer (bind) button
and move and hold the two sticks (as
shown here for activation (A) or
deactivation (B)), while powering on
the transmitter.
3. Release the trainer switch and the
control sticks only after a series of
tones sound (ascending tones for
activation, descending tones for
deactivation).
DX4e and DX5e Expo Activation and Deactivation
If you plan to fl y your Hyper Taxi with a DX4e or DX5e, disconnect the battery from the aircraft before
activating the Expo feature in your transmitter.
Once Expo is activated, it will remain activated for use through subsequent power cycles of the transmitter.
Once Expo is deactivated, it will remain deactivated until it is activated again.
A
B
DX5e
(Modes 1 and 2)
Activate Expo
1. Hold the aileron trim switch to the right when
powering on the transmitter.
2. Release the aileron trim switch after a series
of ascending tones to confirm that Expo is
activated.
Deactivate Expo
1. Hold the aileron trim switch to the left when
powering on the transmitter.
2. Release the aileron trim switch after a series
of descending tones to confirm that Expo is
deactivated.