E-flite Yak 54F 3D ARF - Manual (Page 18)

18
 4. Use tape to hold the rudder in neutral. Slide a
cable crimp onto the control cable. The cable
then goes through the horn, then back through
the crimp. Use pliers to secure the crimp.
 5. Silde the micro cable adjust connector into
the micro control connector and use a 2mm x
3mm screw to hold it in position. Repeat Step 4,
installing the cable through the cable connector.
 6. Remove the tape from the control surface.
Install the second cable following Steps 4
and 5. Tension the cables lightly using the
cable connectors to pull the surface into neutral.