E-flite Yak 54F 3D ARF - Manual (Page 16)

16
 1. Install the plywood control horns for the elevator
and rudder using foam-safe CA. Square the
horns to the control surface.
Linkage Installation
Required Parts
Airframe Cable crimp (8)
Plywood control horn (2) Control cable
Micro control connector (6)
Control connector back plate (6)
2mm x 3mm screw (6)
Micro control horn (2)
Micro control horn back plate (2)
Micro cable adjust connector (4)
Aileron linkage, 6-inch (2)
Long servo arm (3)
Required Tools and Adhesives
Foam-safe CA
Pliers (for crimping)
Phillips screwdriver (small)