E-flite Yak 54F 3D ARF - Manual (Page 11)

11
 2. Pin the string from the previous section into the
top of the fuselage. Check the alignment of the
stabilizer using the string.
 3. Sight down the fuselage and square the
stabilizer to the wing. Sand the opening in the
fuselage if necessary.
 4. Once satisfied with the stabilizer alignment,
use foam-safe CA to glue the stabilizer to the
fuselage. Clean up excess glue with a tissue or
paper towel.
Note : You can use foam-safe Activator to speed
up this CA cure time.