E-flite Funtana 300 ARF - Manual (Page 8)

8 E-flite Funtana 300 Assembly Manual
Airframe Assembly
Required Parts
Fuselage Wing
Stabilizer/elevator Carbon rod, 6-inch (152mm) (2)
Required Tools and Adhesives
Hobby knife Foam-safe CA
Ruler Hinge tape
Low-tack tape
 1. Insert the wing into the fuselage. Measure from the tips
of the wing to the rear of the fuselage. The measurements
must match from right to left. If not, adjust the position of
the wing until both measurements are equal.
A A
A=A
 2. Glue the wing to the fuselage using foam-safe CA.
Allow the CA to fully cure before proceeding. Ensure the
wing is perpendicular to the fuselage during this step.
 3. Use a hobby knife to remove the hinge tape between
the two elevator halves. Also remove the covering from
the slot that will be used for the elevator control horn.