E-flite Funtana 300 ARF - Manual (Page 13)

13 E-flite Funtana 300 Assembly Manual
 6. Attach the Z-bend on the 3 1 /
4
-inch (82mm) carbon
pushrods to the middle hole on the aileron control horns.
 7. Plug the servos into the radio system and make sure
they operate and are centered as well. Also center the
trims on the transmitter at this time. If you are using a
computer radio, start with a clear model program and
check that all sub trims are set to 0 and all throws are set
to 100%.
 8. Attach the single medium servo horn to the servo.
 9. Use a pin drill and 1/16-inch (1.5mm) drill bit to
enlarge the outer hole in the servo arm.