E-flite Funtana 300 ARF - Manual (Page 21)

21 E-flite Funtana 300 Assembly Manual
 3. Use hook and loop tape to mount the receiver to the
side of the horizontal fuselage. Route the antenna wire
from your receiver according to the instructions provided
with your radio system. Plug the servos into the receiver
at this time. Install the speed control in the fuselage using
hook and loop tape. Secure the wires so they will not
interfere with the operation of the motor during flight.
Important Information About Your Brushless ESC
Make sure your ESC brake is programmed to Off. Also,
be sure to use an ESC with the proper low-voltage cutoff
and it is set correctly for the batteries you are using.
 4. Apply hook and loop tape to the motor battery and
fuselage. Slide the motor battery into position.