E-flite Funtana 300 ARF - Manual (Page 18)

18 E-flite Funtana 300 Assembly Manual
Landing Gear Installation
Required Parts
Airframe assembly Landing gear
Nylon wheel retainer (4) 1 1 /
4
-inch (32mm) wheel (2)
Wheel pant(2)
Required Tools and Adhesives
Foam-safe CA Low-temperature hot glue
Hot glue gun
 1. Slide the landing gear into the slot in the bottom of the
fuselage. A drop of foam-safe CA can be placed on the
gear to help keep it in position.
 2. Use foam-safe CA to glue the nylon wheel retainer
to the landing gear. Make sure to allow the CA to fully
cure or you could accidentally glue the wheel to the
landing gear.
 3. Slide the wheel onto the landing gear as shown.