E-flite Mini Pulse XT ARF - Manual (Page 30)

 1. Turn on the transmitter and receiver of your Mini
Pulse XT. Check the movement of the rudder,
elevator and ailerons using the transmitter.
Reverse the direction of the servos at the
transmitter if necessary.
 2. Use a ruler to adjust the throw of the elevator,
ailerons and rudder. Adjust the position of
the pushrod at the control horn to achieve the
following measurements when moving the sticks to
their endpoints.
Measurements are taken at the widest point on the surface.
Low Rate High Rate
Ailerons:
Up/Down 3/8" (9mm) 1/2" (13mm)
Elevator:
Up/Down 1/4" (6mm) 1/2" (13mm)
Rudder:
Right/Left
1 1 /
4
" (32mm) 1 1 /
2
" (38mm)
These are general guidelines measured from our own flight
tests. You can experiment with higher rates to match your
preferred style of flying.
Control Throws
30