E-flite Mini Pulse XT ARF - Manual (Page 24)

Wing Preparation
Required Parts
Wing
6-channel receiver
Servo w/hardware (2)
Servo extension, 6" (152mm)
Y-harness, standard 6" (2)
Control connectors w/backplate (2)
2mm x 4mm screw (2)
4
1
/
4
" (118mm) pushrod wire (2)
Required Tools and Adhesives
Drill
Drill bit: 1/16" (1.5mm)
Screwdriver, #0 Phillips
  1. Secure a 6" (152mm) servo extension onto
the servo lead. Install the aileron servo into the
wing, using the pre-installed string to pull the
servo lead through the wing. The servo lead will
exit the hole in the top center of the wing. Drill
a 1/16” (1.5mm) hole through the tabs on the
servo into the servo mount. Be careful not to
drill through the covering in the top of the wing.
Secure the servo using the hardware that was
provided with the servo.
24