E-flite Mini Pulse XT ARF - Manual (Page 20)

 2. Locate the stabilizer/elevator assembly. Position
the stabilizer/elevator assembly so the control
horn will face down, away from the fin. The
threaded rods from the rudder/fin assembly will
slide into the two holes in the stabilizer.
 3. Slide the rudder/stabilizer assembly onto the
fuselage. Slide the #4 washers onto the threaded
rods. Thread the nuts onto the rod, tightening
them snugly against the bottom of the fuselage.
Note:.The.tail.section.is.removable.for.easy.
transporting.if.needed.
20