E-flite Mini Pulse XT ARF - Manual (Page 25)

  2. Drill a 1/16" (1.5mm) hole in the servo arm
for the pushrod connector. Secure the control
connector in the servo arm using the connector
backplate.
  3. Locate the 4 1
/
4
" (118mm) linkage. Place the
“Z” bend into the center hole of the aileron
control horn. Pass the linkage through the
control connector.
  4. Plug the aileron servo into the receiver. Power
up the transmitter and receiver. Center the aileron
stick, trim, and any programmed sub-trim values.
Install the arm on the servo so it is parallel to the
aileron hinge line. Use a 2mm x 4mm screw to
secure the linkage.
 5. Repeat Steps 1 through 4 for the remaining
aileron servo. Then connect a 6" Y-harness to the
two 6" servo extensions on the servos.
25