Watts PWDWUFKC3 - Manual (Page 3)

3
Operating Temperatures Maximum 100°F (37.8°C) Minimum 40°F (4.4°C)
Operating Pressure
Maximum 85psi
(6.0 kg/cm2)
Minimum 20psi
(2.80 kg/cm2)
pH Parameters Maximum 10 Minimum 5
Flow Rate 0.5 GPM @ 60psi
Operational Parameters
Do not use with water that is micro biologically unsafe or of
unknown quality without adequate disinfection before or after
the system. System is intended to be installed on the cold water
line only.
Contents of UF Under Counter System
1 Filtration System
1 Parts Bag
3 Filters - Attached
1 Faucet Assembly
If any of the items are missing please contact prior to installing.
Tools Recommended for Installation
• Small knife
• Variable Speed Drill
•
1 ⁄
2
" & 5 ⁄
8
" Open End Wrenches
• 1 ⁄
2
" Hole Punch (for stainless steel sinks)
• 1 ⁄
2
" Diamond Tip Drill Bit (for porcelain sinks)
• 1 ⁄
8
" Drill Bit
• 1 ⁄
4
" Drill Bit
• 7 ⁄
16
" Drill Bit
• Phillips Screw Driver
Drill a Hole for the Faucet in a Porcelain Sink
Note: Most sinks are predrilled with 1½" or 1¼" diameter hole
that you can use for your Drinking Water faucet. (If you are
already using it for a sprayer or soap dispenser, see Step A).
Caution: Porcelain sinks are extremely hard and can crack or
chip easily.
Use extreme caution when drilling. Watts accepts no responsi-
bility for damage resulting from the installation of faucet.
Step A – Determine desired location for
the RO faucet on your sink
and place a piece of masking
tape on over where the hole is
to be drilled . Mark the center
of the hole on the tape .
Step B – Using a variable speed drill
set on the slowest speed, drill
a 1 ⁄
8
" pilot hole through both
porcelain and metal casing
of sink at the marked center
of the desired location . Use
lubricating oil or liquid soap
to keep the drill bit cool (If drill
bit gets hot it may cause the
porcelain to crack or chip) .
Step C – Using a 1 ⁄
2
" hole saw, proceed
to drill the large hole . Keep
drill speed on the slowest
speed and use lubricating
oil or liquid soap to keep the
hole saw cool during cutting .
Step D – Make sure the surroundings
of the sink are cooled before
mounting the faucet to the
sink after drilling and remove
all sharp edges .
STEP 1
Punch a Hole for the Faucet in a Stainless
Steel Sink
Note: If mounting faucet to a Stain-
less Steel Sink you will need a 1 ⁄
2
" Hole
Punch. The faucet opening should be
centered between the back splash
and the edge of the sink, ideally on the
same side as the vertical drain pipe.
Step A – Drill a ¼" pilot hole . Use a 1 ⁄
2
"
Hole Punch and an adjustable
wrench to punch the hole in
the sink .
The faucet can now be installed .
OR