BenQ MP510 - Manual (Page 23)

Operation 23
iii. Press Down to cancel the password set-up and return to the OSD menu.
To disable password protection, go to the Setting > Password menu after opening
the OSD menu system. Select Off by pressing Left or Right.
Though the password function is disabled, you need to keep the old password in hand should
you ever need to turn the password function back on and change the old password.
If you forget the password
If the password function is activated, you will be
asked to enter the four digit password every time
you turn on the projector. If you enter the wrong
password, the password error message displays.
You can retry by pressing
Up, or if you did
not record the password in this manual, and you
absolutely do not remember it, you can use the
password recall procedure.
Entering the password recall procedure
Press and hold Right on the projector for 3 seconds. The projector will display 4 sets of
coded number on the screen. Write down the number and turn off your projector. Seek help
from the local BenQ service center to decode the number. You may be required to provide
proof of purchase documentation to verify that you are an authorized user of the projector.
Changing the password
1. Press MENU on the projector or MENU on the remote control to open the on-
screen menu and go to the Setting > Change Password menu.
2. Press Left or Right.
3. Enter the old password.
i. If the password is correct, you can go on to enter new password.
ii. If the password is incorrect, a “Password Error” message displays. Press Up to
try again or press Down to cancel.
4. Enter a new password.
The digits being input will display as asterisks on-screen. Write your selected password
down here in this manual in advance or right after the password is entered so that it is
available to you should you ever forget it.
Password: __ __ __ __
Keep this manual in a safe place.
5. Perform one of the following 3 steps.
i. Press AUTO to confirm.
ii. Press Up to try again.
iii. Press Down to cancel the set-up and return to the on-screen menu.
6. Confirm the new password by re-entering the new password.
7. Perform one of the following 3 steps.
i. Pressing AUTO completes the procedure.
ii. Press Up to try again.
iii. Press Down to cancel the set-up and return to the on-screen menu.
Password error
Try again
Forgot password? Please refer to the User's Manual