BenQ MP510 - Manual (Page 11)

Introduction 11
Remote control
1. Power (See "Start up" on page 21 and
"Shutting down the projector" on page 32
for details.)
Turns the projector on or off.
2. Freeze (See "Freezing the picture" on
page 31 for details.)
Freezes the projected picture.
3. Up, Down, Left, Right (See
"Using the OSD menus" on page 34 for
details.)
When the On-Screen Display (OSD)
menu is activated, the buttons are used as
directional arrows to select the desired
menu items and to make adjustments.
4. MENU (See "Using the OSD menus" on
page 34 for details.)
Displays or hides the On-Screen Display
(OSD) menu system.
5. Keystone (See page "Correcting
keystone" on page 25 for details.)
Manually corrects distorted pictures
resulting from an angled projection.
6. TIMER On/Show (See "Setting the
presentation timer" on page 29 for
details.)
Activates or displays an on-screen timer
based on your own timer setting.
7. TIMER SETUP (See "Setting the
presentation timer" on page 29 for
details.)
Enters presentation timer setting directly.
8. AUTO (See "Auto-adjusting the picture"
on page 25 for details.)
Automatically determines the best
picture timings for the displayed picture.
9. SOURCE (See "Switching input signal"
on page 24 for details.)
Sequentially selects the input signal D-
Sub/Comp. (Component Video), S-Video
or
Video.
10. BLANK (See "Hiding the picture" on page
30 for details.)
Used to hide the screen picture. Press any
key on the remote control to restore the
picture.
11. MODE (See "Selecting a picture mode"
on page 27 for details.)
Sequentially selects a predefined picture
setting available for each input.
1
2
3
3
4
3
5
11
9
10
8
7
6