Brady TLS2200 User Manual

Page 35

Press the <

> key four times to select “Units”, then press .

Press the <

> or <

> keys to toggle the Units to “Metric”, then press .

Press the <

> key four times to select “Printer”, then press .

Press the <

> key five times to select “Term Repeat”, then press .

Use the <

> and <

> keys as needed to set the terminal block repeat value to 6

mm, then press .

Press + to exit back to the Text Editor screen.

With the cursor highlighted on line 1, press + < > > once to increase the font
size from 6 to 7.

10. Enter 101 on line 1.

11. Press <

12. Press + .

13. When “No. to Serial? “ prompt appears, enter 10 , then press .

14. When “No. of Copies?” prompt appears, enter 1.

15. Press or . The printer should print 10 times along the terminal block

marker (101 through 110).

16. Press to advance printed terminal strip label to the cut position.

Maintenance

Keep the TLS2200

™

Thermal Labeling System in good operating condition by performing the

following recommended maintenance procedures.

Cleaning the Drive Roller and Cutter

Follow the instructions on the cleaning card shipped with the unit.

Cleaning the Print Head

Remove the cutter mechanism by loosening the screw that holds it in place. Lift the cutter
away from the the top of the printer mechanism and clean the print head with a cotton swab
dipped in isopropyl alcohol. Replace the cutter mechanism.

Replacing the System Power Cell

A lithium system cell battery maintains the legend and setup memory while power is turned
“OFF.” If “Lithium cell low” appears when turning the printer “ON,” the battery must be