Brady TLS2200 - Manual (Page 31)

30
Creating a Wiremarker
Legend to be printed:
1001
Setup Status:
H Justify: Center
V Justify: Center
Rotation: 0 Degrees
Format: Component
1. Press +
2. Press + <0> to change Format mode from “Component” to “Wire” (note change
from “C” to “W” on Status Bar on LCD).
3. Enter 1001on line 1.
4. Press .
Creating Serialized Wiremarkers
Legends to be printed:
A201 A202 A203 A204 A205
Setup Status:
H Justify: Center
V Justify: Center
Rotation: 0 Degrees
Format: Wire
1. Press to clear the text from line 1.
2. Check the STATUS BAR to make sure the unit is in Wiremarker mode. If not, press
+ <0> to toggle from Component mode to Wiremarker mode.
3. Enter A201on line 1.
4. Press <
=
> to position the cursor under the last character.
5. Press + .
6. When “No. to Serial? “ prompt appears, enter 5 , then press .
7. When “No. of Copies?” prompt appears, enter 2
8. Press or . The printer will begin printing two each of the five
wiremarkers listed above.