Setup via usb port – Belkin ePowerSwitch User Manual

Page 17

Text mode
Original mode

To Save and Exit
If you are satisfied with your configurations, be sure to save
them and exit.

3. Setup via USB port

Before setup you need:

1. IP address: Get a valid IP address from administrator.
2. USB Cable. (Enclose)
3. USB driver and USBSetup file. (Enclose in the disk)

1. Connect the ePowerSwitch to a Windows 98 PC through

an USB cable. If the PC prompts for a new driver, insert
the floppy provided. Uncheck update Windows 98 check
box. It will copy the proper driver from the floppy. Follow
the instructions. The new USB device will be recognized
when the driver is properly installed. No system start up is
required. See the picture below. Sometimes it takes longer