Banner T30 Series - Manual (Page 4)

Specifications
Supply Voltage and Current
20 to 250V ac (50/60 Hz)
Average current: 20 mA
Peak current:
200 mA at 20V ac
500 mA at 120V ac
750 mA at 250V ac
Supply Protection Circuitry
Protected against transient voltages
Output Configuration
SPST solid-state ac switch; three-wire hookup; light op-
erate or dark operate, depending on model
Light Operate: Output conducts when sensor sees its
own (or the emitter’s) modulated light
Dark Operate: Output conducts when the sensor sees
dark
Output Rating
300 mA maximum (continuous)
Fixed-Field models: derate 5 mA/°C above +50° C
(+122° F)
Inrush capability: 1 amp for 20 ms, non-repetitive
OFF-state leakage current: < 100 mA
ON-state saturation voltage: 3V at 300 mA ac; 2V @
15 mA ac
Output Protection Circuitry
Protected against false pulse on power-up
Output Response
Time Opposed mode: 16 ms ON, 8 ms OFF
Other models: 16 ms ON and OFF
NOTE: 100 ms delay on power-up;
outputs do not conduct during this
time.
Repeatability
Opposed mode: 2 ms
Other models: 4 ms
Repeatability and response are independent of signal
strength
Indicators
Two LEDs (Green and Yellow)
Green ON steady: power to sensor is ON
Yellow ON steady: sensor sees light
Yellow flashing: excess gain marginal (1 to 1.5x) in
light condition
Construction
PBT polyester housing; polycarbonate (opposed-mode)
or acrylic lens
Environmental Rating
Leakproof design rated NEMA 6P, DIN 40050 (IP69K)
Connections
2 m (6.5 ft) attached cable, or 4-pin Micro-style quick-
disconnect fitting
Operating Conditions
Temperature: −40° to +70° C (−40° to +158° F)
Humidity: 90% at +50° C maximum relative humidity
(non-condensing)
Vibration and Mechanical Shock
All models meet Mil. Std. 202F requirements. Method
201A (Vibration; frequency 10 to 60 Hz, max., double
amplitude 0.06 in acceleration 10G). Method 213B con-
ditions H&I (Shock: 75G with unit operating; 100G for
non-operation)
Certifications
T30 Sensors - AC-Voltage Series
4 www.bannerengineering.com - tel: 763-544-3164 P/N 121523 Rev. A