Banner MINI-BEAM2 QS12 Series - Manual (Page 5)

P/N 59040 rev. B
5
MINI-BEAM ® 2 QS12 Series
Miniature Photoelectric Sensors
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Supply Voltage 10 to 30V dc (10% maximum ripple) at less than 25 mA, exclusive of load
Supply Protection Circuitry Protected against reverse polarity and transient voltages
Output Configuration Solid state complementary (SPDT): NPN or PNP (current sinking or sourcing) output models available
Output Rating 150 mA maximum each output at 25°C
OFF-state leakage current: less than 10 µA @ 30V dc
ON-state saturation voltage: less than 1V @ 10 mA; less than 2.0V @ 150 mA
Output Protection Circuitry Protected against false pulse on power-up and continuous overload or short circuit of outputs
Output Response Opposed Mode: 8 milliseconds ON, 4 milliseconds OFF
All others: 1.5 milliseconds
NOTE: 500 millisecond delay on power-up, outputs do not conduct during this time
Repeatability Opposed Mode: 1 millisecond
All others: 175 microseconds
Adjustments One rubber-sealed push button
Hold: Maximum gain
Click: Reduce gain one increment
Indicators 2 LEDs, visible from back and sides of sensor: 1 green, 1 amber
Green steady: Power ON
Yellow steady: Light sensed
Green flashing rapidly 5 times: Maximum gain
Single Green flash: Click registered, gain reduced by one increment (total of 8)
Yellow/Green alternating: Minimum gain (can not reduce further)
Construction Black polycarbonate/ABS alloy housing; totally encapsulated circuitry
Environmental Rating IEC IP67; NEMA 6
Connections 2 m (6.5’) 4-wire PVC cable, 9 m (30’) PVC cable, or 4-pin Pico-style 150 mm (6”) pigtail QD
Operating Conditions Temperature: -20° to +55° C (-4° to +131° F)
Relative Humidity: 90% @ 50° C (non-condensing)
Certifications
Specifications