Banner WORLD-BEAM QS30 Series - Manual (Page 2)

Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN USA 55441 • Phone: 763.544.3164 • www.bannerengineering.com • Email: [email protected]
WORLD BEAM ® QS30 – Universal Voltage
WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year.
Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture found to
be defective at the time it is returned to the factory during the warranty period. This warranty does not
cover damage or liability for the improper application of Banner products. This warranty is in lieu of any
other warranty either expressed or implied.
P/N 119168 rev. B
Supply Voltage and Current
Universal Voltage: 24 to 250V ac, 50/60 hz or
12 to 250V dc (1.0 watt maximum)
Supply Protection Circuitry
Protected against transient voltages
Output Configuration
SPDT (Single-Pole Double-Throw) electromechanical relay output
(all models except emitters)
Output Rating
Max. Switching Power (resistive load): 150 W, 1250 VA
Max. Switching Voltage (resistive load): 250V ac; 125V dc
Max. Switching Current (resistive load):
5 A @ 250V ac
5 A @ 30V dc derated to 200 mA @ 125V dc
Min. Voltage and Current: 5V dc, 10 mA
Mechanical life of relay: 50 million operations
Electrical life of relay at full resistive load: 100,000 operations
Output Response Time
15 milliseconds ON and OFF
NOTE: 100 millisecond delay on power-up; output does not conduct during
this time.
Cutoff Point Tolerance
Fixed-Field Only: ± 5% of nominal cutoff distance
Indicators
2 LED indicators on sensor top:
Green ON steady: Power ON
Yellow ON steady: Light sensed
Yellow flashing: Marginal excess gain (1.0 to 1.5x excess gain)
Large, oval LED indicator on sensor back (except emitters):
Yellow ON steady: Normally open output is conducting
Construction
ABS housing, rated IEC IP67; NEMA 6; Acrylic lens cover
Connections
2 m (6.5') or 9 m (30') 5-wire PVC cable
Operating Conditions
Temperature: -20° to +70° C (-4° to +158° F)
Relative Humidity: 90% @ 50° C (non-condensing)
Certifications
Specifications
Additional information on this product is immediately available online at www.bannerengineering.com/119166
View or download additional information, including excess gain curves, beam patterns and accessories.
For further assistance, contact a Banner Engineering Applications Engineer at (763) 544-3164 or (888) 373-6767.
US