Banner SureCross DX81 FlexPower Supply Module User Manual
Surecross dx81 flexpower supply module, Datasheet, Pin euro-style female wiring for dx81

Datasheet
The DX81 Battery Supply Module delivers and manages dc voltage from one 3.6 V dc
lithium primary battery.
•
Wireless solution for powering a FlexPower
®
Node and sensor device
•
Unique power management system to run the FlexPower Node and a device
through switched power outputs for up to 5 years, depending upon the power
requirements of the device
•
Replaceable 3.6 V dc Lithium “D” cell battery
•
IP67 sealed enclosure
FlexPower systems allow for a true wireless solution because the Node can be powered
by battery power (3.6 to 5.5 V dc). Battery life is application specific. Contact Banner
Engineering’s application engineers for a battery life calculation for your specific
application.
For additional information, updated documentation, and accessories, refer to Banner
Engineering's website,
.
Model
Power
Battery
Cable
DX81
3.6 V dc battery
One 3.6 V Lithium "D" Cell
5-pin Euro pigtail QD
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to
serious injury or death. This device does not include the self-checking redundant circuitry necessary
to allow its use in personnel safety applications. A sensor failure or malfunction can cause either an
energized or de-energized sensor output condition.
5-pin Euro-Style Female Wiring for DX81
Use the battery supply module to power FlexPower
®
devices only.
5-pin Euro-Style Female
Connector
Wire No.
Wire Color
Description
DX80...C Terminal
Labels
1
2
3
4
5
3
Blue
dc common (GND)
V-
5
Gray
1
3.6 V dc
B+
Replacing the Battery (DX81 and DX81H Battery Supply Module)
For outside or high humidity environments, apply conductive grease to the battery terminals to prevent moisture and
corrosion buildup.
To replace the lithium "D" cell battery in the DX81 FlexPower
®
battery kit, follow these steps.
1. Unplug the battery device from the SureCross device it powers.
2. Remove the four screws mounting the battery pack face plate to the body and remove the face plate.
1 Do not apply more than 5.5 V dc to the gray wire.
SureCross DX81 FlexPower Supply Module
P/N 131596 Rev. E
2 January 2014
0 131596
7