Installation, Wiring – Banner VTB Verification Touch Buttons User Manual

Page 3

Installation

Consider ergonomic principles to avoid unnecessary fatigue in the installation of the hand controls. Install the touch buttons at a height
and in a location that will be comfortable for the user.

The following figure shows two methods for mounting the touch buttons, to prevent accidental switch actuation. When mounting them on
top of the control bar, the protective field covers should be in place, as shown; or for added protection, mount the touch buttons sideways
under and/or behind a protective hood, rather than on top of the bar, without using the field covers. This side mount prevents an object
from being left in the path of the beam. In addition, shields, covers, rings, collars, dividers, or similar protection may be used to prevent
accidental switch actuation.

Figure 1. Protect VTB touch buttons to prevent defeat or inadvertent actuation

Wiring

Single-color models may be wired for either a solid or flashing job light. The wiring of two-color models determines the job light. Color
flashing job light is not available. Cabled model wiring shown. Cabled and QD model wiring is functionally identical.

• For solid color, use the standard wiring diagram.
• For flashing (2 Hz), use the alternate wiring diagrams.

One-Color Job Light, NPN
(Sinking) Output Models

One-Color Job Light, PNP
(Sourcing) Output Models

Two-Color Job Light Models

Wiring Key

Solid Job Light

NPN (Sinking) Output Models

1 = Brown
2 = Blue
3 = Black
4 = White
5 = Gray
6 = Load
7 = Job light enable
8 = Green job light
9 = Red job light

bn
bu

bk
wh

12-30V dc

Job Light Enable
0V dc

Load

bn
bu

bk
wh

12-30V dc

Job Light Enable
+10-30V dc

Load

bn
bu

bk
wh
gy

12-30V dc

Green Job Light Enable — 0V dc
Red Job Light Enable — 0V dc

Load

Flashing Job Light

PNP (Sourcing) Output Models

Pinouts

bn
bu

bk
wh

12-30V dc

Job Light Enable
+10-30V dc

Load

bn
bu

bk
wh

12-30V dc

Job Light Enable
0V dc

Load

bn
bu

bk
wh
gy

12-30V dc

Green Job Light Enable — +10-30V dc
Red Job Light Enable — +10-30V dc

Load

VTB Pick-to-Light Optical Touch Button

P/N 067570 Rev. C