Banner Q08 Series - Manual

Low-profile infrared sensors in rugged metal housings
• Miniature right-angle dc photoelectric sensors in rugged die-cast metal housings
• Ultra-thin; only 8 mm (0.3") deep
• Totally self-contained; 10 to 30V dc operation
• Easy mechanical alignment
• Circuitry is completely sealed and epoxy-encapsulated; rated IP67 and NEMA 6
• Select models with NPN (sinking) or PNP (sourcing) output
• Select light operate or dark operate models
• 3-wire hookup; output load capacity to 150 milliamps
• LED indicators for Power ON and Output ON; Output indicator may be used for
alignment
• Infrared, 880 nm
• Range of 2.5 mm to 61 mm (0.1" to 2.4")
DIFFUSE
Models Cable
Output
Type
Excess Gain Beam Pattern
NO5-Q08-AN7
NO5-Q08-AN7V1131 2 m (6.5 ft)
3-Pin Pico QD
NPN/LO
1
10
100
10 mm
0.4 in
100 mm
4.0 in
1000 mm
40 in
1 mm
0.04 in
1000
E
X
C
E
S
S
G
A
I
N
DISTANCE
Q08
Diffuse Mode
52.5 mm
2.5 in
40.0 mm
2.0 in
37.5 mm
1.5 in
25.0 mm
1.0 in
12.5 mm
0.5 in
0
0
2.5 mm
5.0 mm
7.5 mm
2.5 mm
5.0 mm
7.5 mm
0
.1 in
.2 in
.3 in
.1 in
.2 in
.3 in
Q08
Diffuse Mode
DISTANCE
NO5-Q08-RN7
NO5-Q08-RN7V1131 2 m (6.5 ft)
3-Pin Pico QD
NPN/DO
NO5-Q08-AP7
NO5-Q08-AP7V1131 2 m (6.5 ft)
3-Pin Pico QD
PNP/LO
NO5-Q08-RP7
NO5-Q08-RP7V1131 2 m (6.5 ft)
3-Pin Pico QD
PNP/DO
Standard 2 m (6.5 ft) cable models are listed. To order the 9 m (30 ft) cable model, add suffix "W/30" to the cabled model number. For
example, NO5-Q08-AN7 W/30. Models with a QD connector require a mating cable. Performance based on 90% reflective white test
card.
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to serious
injury or death. This device does not include the self-checking redundant circuitry necessary to allow its
use in personnel safety applications. A sensor failure or malfunction can cause either an energized or de-
energized sensor output condition.
Q08 Series Opposed-Mode Sensors
P/N 03558 Rev. E 8/19/2013