Metrohm 859 Titrotherm - Manual (Page 20)

3.3 Connecting MSB devices ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
12 ￭￭￭￭￭￭￭￭ 859 Titrotherm
MSB
Stirrer / Ti Stand
Dosino
Remote Box
Dosino
Dosino
Relay Box
Ti Stand / Stirrer
Figure 6 MSB connections
The question of which peripheral devices are supported depends on the
control device.
Note
When connecting MSB devices together, the following must be
observed:
￭ Only one device of the same type can be used at a single MSB con-
nector at one time.
￭ Type 700 Dosino dosing devices cannot be connected together with
other MSB instruments on a shared connector. These dosing devices
must be connected separately.
Caution
Exit the control software before you plug MSB instruments in. When
the control device is switched on, it automatically recognizes which
instrument is connected at which MSB connector. The control software
enters the connected MSB devices into the system configuration (device
manager).
MSB connections can be extended with the 6.2151.010 cable. The maxi-
mum connection length permitted is 15 m.