Metrohm 807 Dosing Unit - Manual (Page 20)

3.3 Connecting a computer
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
12 ￭￭￭￭￭￭￭￭
846 Dosing Interface
6.2151.000
Figure 5 Connecting the computer
The instrument is recognized. The driver installation is carried out dif-
ferently, depending on the version of the Windows operating system
used.
￭ Either the required driver is installed automatically, or an installa-
tion wizard is started.
3 Follow the instructions of the installation wizard.
The "On" LED on the 846 Dosing Interface lights up when the driver
installation has been exited and the instrument is ready for operation.
If problems should occur during installation, contact your company's IT
supporter.
Note
The plug on the instrument end of the 6.2151.000 controller cable is
protected against accidental disconnection by means of a pull-out pro-
tection feature. If you wish to pull out the plug, you will first need to
pull back the outer plug sleeve marked with arrows.
Registering and configuring the instrument in the PC soft-
ware
The instrument must be registered in the configuration of your PC soft-
ware. Once that has been done, you can then configure it according to
your requirements. Proceed as follows:
1 Set up the instrument
￭ Start the PC software.
The instrument is automatically recognized. The configuration dia-
log for the instrument is displayed.