DJI DR16 - Manual (Page 3)

©2013 DJI Innovations. All Rights Reserved.
- 3 -
Remote controller Power LED Indicator Status Information
Power LED Indicator Sound Remote Controller Status
None Normal
B-B-B…… Low voltage (at 4V-4.3V). Replace the batteries immediately
B--B--B……
Alarm will sound after 15 minutes without activity. It will stop once you
start using the remote controller.
Important: The remote controller will power off automatically when battery voltage drops below 4V. Land and
change batteries as soon as possible when the low voltage alert occurs to avoid loss of control during flight.
Connecting the DR16 Receiver to the Flight Control System
The DR16 Receiver is designed to be used with the below flight control system. Connect the DR16 receiver to the
correct port on the main controller in the flight control system using a 3-Pin cable, then select the D-BUS receiver
type in the Assistant software.
Flight Control
System
NAZA-M Lite NAZA-M NAZA-M V2 WooKong-M A2
Port on the Main
Controller
X2 X2 X2 X2 X2
Linking the DT7&DR16
1. Power on the main controller and the DR16 receiver.
2. Turn on the remote controller and place the remote controller 0.5m~1m from the receiver.
3. Poke the link button with a thin object and hold it until the LED indicator on the receiver blinks red, then release
it.
4. When the LED indicator becomes solid green, the link between the DT7 remote controller and the DR16 receiver
has been successfully established.
The LED Indicator Status of DR16
LED Indicator Status
The remote controller is linked with the receiver successfully
The remote controller is turned off and there is no 2.4GHz signal around
The receiver is ready for linking
There is 2.4GHz signal around but the remote controller is not linked with the
receiver
Usages of the RC SYSTEM Assistant software
The RC SYSTEM assistant software is used to configure the DT7 remote controller, upgrade its firmware, select the
sticks mode and calibrate the sticks.
Download & Installation & Connection
1. Download the driver and RC SYSTEM Assistant software, then install the diver and software on your PC.
2. Turn on the remote controller and connect it to the PC by Micro-USB cable.