Decimator Design MD-DUCC User Manual

Page 8

GPI (General Purpose Inputs)
Configuration 1 (Tallies)

NAME

DESCRIPTION

GREEN_TALLY_EN

Ground pin to enable Green Block Tally

RED_TALLY_EN

Ground pin to enable Red Block Tally

BLUE_TALLY_EN

Ground pin to enable Blue Block Tally

RX+

RS422/RS485 Positive Receive Pin

RX‐

RS422/RS485 Negative Receive Pin

GREEN_BORDER_EN Ground pin to enable Green Border

RED_BORDER_EN

Ground pin to enable Red Border

GROUND

Use as reference ground.

Notes:

1. The border will be Yellow when both GREEN_BORDER_EN and RED_BORDER_EN are

enabled.

2. The border will end at the Safe Action Graticule, adjust this to move it in or out.

SERVICE WARRANTY

Decimator Design warrants that this product will be free from defects in materials
and workmanship for a period of 12 months from the date of purchase. If this
product proves to be defective within this warranty period, Decimator Design, at its
discretion, will either repair the defective product without charge for parts and
labour, or will provide a replacement product in exchange for the defective product.

In order to service under this warranty, you the Customer, must notify Decimator
Design of the defect before the expiration of the warranty period and make suitable
arrangements for the performance of service.  The Customer shall be responsible for
packaging and shipping the defective product to a designated service centre
nominated by Decimator Design, with shipping charges prepaid.  Decimator Design
shall pay for the return of the product to the Customer if the shipment is to a
location within the country in which the Decimator Design service centre is located.
The Customer shall be responsible for paying all shipping charges, insurance, duties,
taxes, and any other charges for products returned to any other location.

This warranty shall not apply to any defect, failure or damage caused by improper
use or improper or inadequate maintenance and care. Decimator Design shall not
be obligated to furnish service under this warranty a) to repair damage resulting
from attempts by personnel other than Decimator Design representatives to install,
repair or service the product, b) to repair damage resulting from improper use or
connection to incompatible equipment, c) to repair any damage or malfunction
caused by the use of non‐Decimator Design parts or supplies, or d) to service a
product that has been modified or integrated with other products when the effect of
such a modification or integration increases the time of difficulty of servicing the
product.