Decimator Design MD-CROSS - Manual (Page 10)

MD‐CROSS OPERATING MANUAL VERSION 1.0
Copyright © 2013 Decimator Design Pty Ltd, Sydney, Australia 10
1.) None
2.) Bar Only
3.) Float Only
4.) Bar and Float
7. Audio Meter / Transparency (Parameter)
This is the transparency level of the audio meter overlays.
When the sub menu is highlighted, press ENTER to toggle through the following selections:
1.) 0%
2.) 25%
3.) 50%
8. Audio Meter / Show Scale (Parameter)
This indicates if the scale is shown on the audio meter overlays.
When the sub menu is highlighted, press ENTER to toggle through the following selections:
1.) Off
2.) On
9. Audio Meter / Bar Scale (Parameter)
This is the current scale shown on the audio meter overlays.
When the sub menu is highlighted, press ENTER to toggle through the following selections:
1.) AES/EBU
2.) VU
3.) Extended VU
4.) BBC PPM (IEC 2a)
5.) EBU PPM (IEC 2b)
6.) DIN PPM (IEC 1a)
7.) NORDIC (IEC 1b)
10. Audio Meter / Bar Ballistics (Parameter)
This is the current ballistics applied to the bar audio meter.
When the sub menu is highlighted, press ENTER to toggle through the following selections:
1.) VU
2.) IEC1
3.) IEC2
11. Audio Meter / Float Ballistics (Parameter)
This is the current ballistics applied to the float audio meter.
When the sub menu is highlighted, press ENTER to toggle through the following selections:
1.) VU
2.) IEC1
3.) IEC2
12. Audio Meter / Ref Level (Parameter)
This is the current audio reference level for the audio meter overlays.
When the sub menu is highlighted, press ENTER to toggle through the following selections:
1.) ‐20 dBFS
2.) ‐18 dBFS
3.) ‐15 dBFS
13. Audio Meter / Yellow Start (Has SUB‐MENU with parameter)
This is the starting level for the yellow range on the audio meter. The value default is ‐10dBFS.
When the sub menu is highlighted, press the ENTER button to enter this sub‐menu.
Press the < and > buttons to increase and decrease the level respectively from 0 to ‐100dBFS.
Press the BACK button to leave this SUB‐MENU.