CommScope PWR-COBRA-1 RET Antenna System - Manual (Page 6)

Andrew, A CommScope Company
3 Westbrook Corporate Center, Suite 900, Westchester, Illinois U.S.A. 60154
U.S.A.: +1 (800) 279-8185 • International: +1 (703) 726-5556
WWW.CommScope.Com
© 2008 CommScope
639568 • Revision C • November 2008
Page 6 of 6
SAFETY NOTICE
The installation, maintenance, or removal of an antenna
requires qualified, experienced personnel. Andrew
installation instructions are written for such installation
personnel. Antenna systems should be inspected once a
year by qualified personnel to verify proper installation,
maintenance, and condition of equipment.
Andrew disclaims any liability or responsibility for the
results of improper or unsafe installation practices.
Do not install near power
lines. Power lines,
telephone lines, and guy
wires look the same.
Assume any wire or line
can electrocute you. Do not install on a wet or
windy day or when
lightning or thunder is in
the area. Do not use
metal ladder. Wear shoes with rubber
soles and heels. Wear
protective clothing
including a
long-sleeved shirt and
rubber gloves.
WARRANTY NOTICE
Proper installation, procedures must be followed when
installing and operating RET equipment. Failure to assure
installations are done by properly trained installation
personnel and follow Andrew’s documented procedures
may cause warranty for such products to be void.
Andrew requires that all RET installations be pre-tested
and configured prior to installation. Failure to conduct pre-
test and pre-installation procedures defined by Andrew will
void warranty.