CommScope ATC300-2000 - Manual (Page 7)

• Enter the new electrical tilt angle
Figure 4-2. Adjusting tilt for antennas in the same sector.
and click on Set Tilt. See Figure 4-1,
Screen 2.
2. Device adjustments for a group of
antennas:
Click on a device that is to be
in-cluded in the sector move, and
click Move Sector (Screen 1). The
3. Adjusting the downtilt angle on a group of antennas:
• Click on the Additional models, one at a time, to be included in the sector move (Figure 4-2).
Antennas are listed in the Additional box only if they have the same sector and tilt range as
the selected antenna.
dialog box to Set Electrical Tilt for
Sector x
Figure 4-1. Adjusting Tilt For One Antenna.
appears (Figure 4-2).
4.0 Adjusting Electrical Tilt
1. Device adjustments for a single
antenna:
• Start at the controller’s main
inter-face screen. To change electrical
downtilt on a single antenna, select
the antenna actuator to be tilted, and
click Move Selected. See Figure 4-1,
Screen 1.
• Click on Add to move the selec-tion to
Included. Double-clicking on the model
will also add it to the group for the
sector move.
• Enter the new electrical tilt angle.
Review the electrical tilt range to verify
that the new tilt angle entered is valid
for the antenna model. Any downtilt
angle within this range may be entered.
Angles may be entered with the
precision of 0.1 degree (Example: 5.0 or
5.5).
• Click on Set Tilt.
Bulletin 639572 • Revision F • December 2012 Page 7 of 7
ATC300-1000/2000 Teletilt® Control System Computer Interface Setup