0 device configuration – CommScope ATC300-2000 User Manual
Page 6
to return to the controller’s main screen when device configuration is complete.
Edit Selected
1. Select appropriate device to be configured and click on
3.0 Device Configuration
(Figure 3-1).
Figure 3-1. Starting the Device Configuration.
2. Make appropriate selections and text entries on screen below.
• To receive commands from the controller, a device must be configured to provide specific
information about the antenna and its location on site.
• Factory installed actuators are pre-configured to include the antenna model number, antenna
type, and antenna serial number.
• The remaining fields (Installation Date, Base Station ID, Mechanical Tilt, Technology, Freq. Band,
Sector, Location, Bearing, Height, and Installer ID) will need to be configured.
• After entering data, click on Set Device Data (Figure 3-2).
Note: Click on Close
Figure 3-2. Device Configuration.
ATC300-1000/2000 Teletilt® Control System Computer Interface Setup
Bulletin 639572 • Revision F • December 2012 Page 6 of 7