Troubleshooting video output – ClearCube M1020W-Series Engineering Workstation User Manual
Page 13
Page 13 of 14
P/N G0200157 Rev E, 1.4.12.11.2014
ClearCube Technology, Inc.
3700 W Parmer Lane
Austin, TX 78727
(512) 652-3500
www.clearcube.com
Troubleshooting Video Output,
Continued
Setting the BIOS
VGA option
(continued)
Step
Action
5
Select PCIe/PCI/PnP Configuration and press the ENTER key.
6
Select VGA Priority and press the ENTER key.
7
Select Offboard and press the ENTER key.
8
Press the F4 key to save your changes and exit. Select Yes and then press ENTER.
NOTE: The connected VGA monitor will show POST messages and pause at an
animated
System Initializing
message. This is normal operation.
If installed, the workstation boots to the installed operating system.
You can now reconnect cables (see “
”) and connect to the
workstation from a zero client.
For local management, you can connect a USB keyboard and mouse to the workstation and then
remove the video cable connecting the PCoIP Host Card and the GPU on the rear of the workstation.
Then connect a monitor directly to the GPU.