Calculated Industries 6260 User Guide - Manual (Page 45)

SENDING VALUES TO YOUR PC (PC SEND)
The [PC Send] key sends the displayed value from the Puck to the selected software program on your PC. Values can be sent to the
PC during a measurement and after it has been completed.
Only numeric values can be sent to the PC. Preference settings and error messages cannot be sent to the PC. Also, the following
measurement prompts cannot be sent to the PC:
Start.Pt Point 2 Ent Pt.1
High Pt Point 3 Ent Pt.2
Final.Pt
Note: Values cannot be sent to the PC while setting a Custom Scale or setting a Height.
There are three Preferences that determine how values are sent to the PC (see Preferences section for information on accessing and
changing the Preferences).
PC SEND TERMINATING COMMAND:
Enter * - Performs an ENTER command after
value is sent to the PC.
Tab - Performs a TAB command after value
is sent to the PC.
Left - Performs a LEFT command after value
is sent to the PC.
Right - Performs a RIGHT command after
value is sent to the PC.
Up - Performs an UP command after value
is sent to the PC.
Dn - Performs a DOWN command after
value is sent to the PC.
None - Performs no action after value is sent
to the PC.
PC SEND DISPLAY:
Hold* - The displayed value is not cleared
after being sent to the PC.
Clr - The displayed value is Cleared after
being sent to the PC. This setting is
ignored while measuring.
USB SEND DELAY:
Delay 1 * - FASTEST USB send speed.
Delay 2 - MEDIUM USB send speed.
Delay 3 - SLOW USB send speed.
Delay 4 - SLOWEST USB send speed.
Use this setting to reduce the USB send speed if
using a slower computer and experiencing problems
sending values.
*An asterisk denotes a default value.
U
SER’S
G
UIDE
— 43