Calculated Industries 6260 User Guide - Manual (Page 43)

DIGITIZER MODE
The Ultra Scale Master Pro can be used as a Digitizer to send measurement data (X,Y coordinates) and key press data to digitizing
software on a host personal computer (PC). See PC Interface section for system requirements and USB connection information.
Press the [DIGITIZER] key to enter Digitizer Mode. Display will show “digi On.” It will remain in Digitizer Mode until the
[DIGITIZER]
key is pressed again, or when a manual reset is performed (see Reset section).
WHILE IN DIGITIZER MODE:
The following keys send measurement data (X,Y coordinates) and key press data:
[MEASURE]
[END]
[CLOSE –]
[CLOSE +]
The following keys send only the key press data:
[UNDO] D-Pad Up [5] [PC SEND] [MODE] [HEIGHT]
D-Pad Down [6] [ARC/CIRC] [SCALE] [PREFS]
[M+] D-Pad Right [4] [MR] [UNITS]
D-Pad Left [3]
The following keys send no data:
[ON/CLEAR]
[SET]
[DIGITIZER]
U
SER’S
G
UIDE
— 41