Calculated Industries 6260 User Guide - Manual (Page 38)

There are two methods for programming Custom Scales
into your Ultra Scale Master Pro. “Measured Custom Scales”
allow you to measure a specifi ed Length and assign the
known value. “Entered Custom Scales” allow you to enter
and set a known scale that is not included within the
available built-in scales of the Ultra Scale Master Pro. Four Custom Scales can be stored in Imperial and Metric
Modes for a total of eight Custom Scales. Once a Custom
Scale has been set in either mode, it is retained until a new
scale is stored in its place or until an All Clear or Reset is
performed. Switching between Imperial and Metric Modes
does not clear stored Custom Scales.
SETTING A MEASURED CUSTOM SCALE
CUSTOM SCALES
1. Press [MODE] until “CUST” is displayed. Press [SCALE]
to scroll through the four available custom scales. For this
example, Custom Scale-1 is used.
2. Press [SET] then [SCALE] to begin setting the Custom
Scale. The display prompts you to enter Point-1.
3. Place the crosshairs over the start point of the line and
press [MEASURE]. You are prompted to enter Point-2.
4. Place the crosshairs over the end point and press
[MEASURE] . The display shows “0,000-00” for Imperial
Mode and “00,000.0” is displayed for Metric Mode.
36 — U
LTRA
S
CALE
M
ASTER ®
P
RO