Calculated Industries 6260 User Guide - Manual (Page 24)

MEASURING SIMPLE POLYGONS
OPERATING SEQUENCE
1. Press the [ON/CLEAR] key twice to clear the display.
Place the crosshairs over the fi rst point and press the
[MEASURE]
key.
2. Move to the second point and press the [MEASURE] key.
The display will show the Length of the fi rst line segment.
3. Move to the third point and press the [MEASURE]
key. The display will show the accumulated Length
of the two measured segments.
4. Move to the fourth point and press the [MEASURE] key.
The display will show the accumulated Length of the
three measured segments.
1
3 2
1
2
3
4
4
22 — U
LTRA
S
CALE
M
ASTER ®
P
RO
5