Calculated Industries 6135 - Manual (Page 29)

(cont’d)
4) Once the desired value has been entered,
press [SET] to save changes and put the
unit into Auto-Count mode.
5) Roll a distance. The unit will beep each
time you roll the programmed distance.
The count number in the display will
increase.
6) Press [SET] [COUNT] to exit Auto-Count
mode.
Setting a Constant (+K)
This function is used to store a constant
value. Once a constant value has been
stored, pressing
[+K] will add that value to
the displayed measurement.
To set a constant:
1) Press
[SET] [+K] to access the constant
function. The appropriate annunciator
will begin flashing “
FT IN ” for Imperial
Mode or “ M ” for Metric Mode. “ PLUSk ”
will appear in the display.
25 – Scale Master
®
Pro XE