beautypg.com

Caution, Removing the transport bolts – Bosch maxx 800 Series User Manual

Page 8

background image

8

Removing the transport

bolts

d

CAUTION

To avoid possible injury and damage

to the appliance and adjacent

surfaces, all four transport bolts

must be removed before using the

appliance. Retain the bolts for use

in any future transport (e.g. when

moving). If you have purchased a

pedestal mounting kit, follow the

installation instructions provided

with it before removing the transport

bolts.

q

Loosen all four bolts before

removing any of the bolts all the

way from the unit.

q

Remove the bottom two bolts prior

to removing the top two bolts.

Remove the bolts in the order

shown in the diagram below.

q

Loosen the bolts using the closed

end of the 1/2" wrench provided.

Loosen them until they can be reĆ

moved freely.

q

The recessed bottom bolts may be

easier to remove using a 1/2" (13

mm) socket wrench.

q

Completely remove all 4 transport

bolt assemblies (bolt, spring, washer

and bushings). Pull the washer

drum slightly forward towards the

open washer door to reduce

pressure on the transport bolt

assemblies. Slide each loosened

transport bolt assembly out of its

retaining slot, then pull it out through

the round hole in the housing.

q

If the bushings do not come out

when removing the bolts, place the

bolts back into the bushings and

carefully try again. It is important to

do this with the bolts, otherwise the

bushings will not come out properly.

q

To store the bolts for future use, do

not remove the bolts from the

plastic bushings.

q

Position the plastic cover over the

hole the transportation bolts

occupied. Push the tab in (A) and

slide the cover towards the small

slot (B).

Storing the transport bolts

Always keep the transport bolts for fuĆ

ture transportation of the appliance

(such as when moving out).

q

Store the transport bolts with the

washer and bushing attached.