Bully Dog 51101 Rapid Flow Induction - Manual (Page 9)

8
RAPID FLOW INDuCTION
FILTEr mAINTENANCE:
The intake system should be cleaned at least every three months; in dusty climates the filter should
be cleaned more often. Cleaning the intake is a two part process, the first part of the process
involves the physical cleaning of the filter with soap and water and the second part involves
oiling the filter. To properly clean the filter a Bully Dog cleaning kit should be used. Cleaning kits
are available at any Bully Dog dealer.
part.1,.cleanIng.the.fIlter:
1. Remove filter from filter housing. Clean the filter housing if
necessary.
2. Begin the cleaning process by ridding the filter of any dirt by
lightly tapping it. Then brush away any loose particles with a
soft-bristle brush. This step can usually be avoided with the
use of a prefilter.
3. Spray cleaner generously over entire filter and let soak for
10 minutes.
4. Thoroughly rinse the filter with regular tap water (avoid
high-pressure hoses). Flush from the inside out or clean side
to the dirty side to prevent dirt from entering the filter.
5. Let the filter air dry before oiling, do not use any method to speed up the drying process. Using
a blow dryer or compressed air can cause the filter to disfigure which would then allow particles
to pass through the filter.
part.2,.oIlIng.the.fIlter:
1. Apply a small amount of oil to the soft bristle brush and spread the oil over the filter. Be sure to
apply a small amount of force so not to damage the filter element.
2. Continue applying oil to the filter using a soft bristle brush until the entire filter is covered in an
even amount of oil, just enough to give the filter a solid blue color. Apply enough oil to make the
filter a solid and uniform blue, but do not go beyond that.
3. Allow oil to sit for 20 minutes. Re-oil any dry spots that appear. Do not oil filter excessively. Exces-
sive oiling can cause damage to intake sensors.
part.#:.229000
cleanIng.kIt