Bully Dog 51101 Rapid Flow Induction - Manual (Page 6)

5
RAPID FLOW INDuCTION
INSTALLINg ThE rFI
1. Notice the two holes at the bottom of
the intake seat inside the engine bay.
When setting the RFI into place, the
rods on the bottom of the RFI will need
to set into the two holes.
2. Set the front end of the RFI into the engine bay and snug it up to the radiator, then slide the
back side of the intake down into place. Make certain that the rods on the bottom of the RFI
have correctly set into the holes on the bottom of the intake seat.
pre-InstallatIon.procedure
On 2005 models remove the rubber grommet that holds
the Mass Air Flow sensor in place from the stock intake
housing. Install the rubber grommet into the RFI in the pre-
drilled hole on the intake outlet tube.