Bully Dog 51101 Rapid Flow Induction - Manual (Page 4)

3
RAPID FLOW INDuCTION
rEmOvINg ThE STOCk INTAkE
1. Disconnect the coolant overfill hose, this will make the
removal of the stock intake easier.
2. Disconnect the Mass Air Flow sensor:
• (‘03, ‘04, ‘06, ‘07) Using a bit driver
and the torques bit included unscrew
the torques screws that hold the mass
air flow sensor onto the air intake exit
tube. Once the screws are out pull the
mass air flow sensor out of the tube,
disconnect it from the harness holder
and move it aside while completing
the installation.
• 2005 The mass air flow sensor sits in a
grommet that holds it in place on the
intake exit tube. Remove the MAF sen-
sor by simply pulling up on the sensor,
then disconnect it from the harness
holder and move it aside while com-
pleting the installation. Also remove
the grommet that holds the MAF sen-
sor in place from the stock intake, that
grommet will need to be installed on
the RFI along with the MAF sensor.