Bully Dog 81020 Rapid Flow - Manual (Page 7)

6
6
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81020
2. Place all of the supplied Hangers into their appro-
priate locations as shown in the above diagram.
3. Install the Down Pipe. You will use the stock band
clamp to secure the Down Pipe to the turbo. Secure
the Down Pipe by tightening the stock band clamp
with a 7/16” deep socket.
4. Hang the Adapter Pipe from Hanger A and secure
the Pipe to the Down Pipe using one of the supplied
clamps. At this point, secure the connection so that
the piece will stay, but do not tighten down until
the entire exhaust is installed.
5.At this point, you will skip installing
the straight pipe and muffler and
continue working from the rear of
the vehicle.
Secure Down Pipe with Stock Band Clamp
Down Pipe
Stock Band Clamp
7/16”
Hang the Hangers
5” Adapter with Offset
Hanger A
Second Piece Down Pipe
Install Down Pipe
Install 5” Adapter with Offset
Down Pipe
Clamp
Second Piece Down Pipe