Bully Dog 81020 Rapid Flow - Manual (Page 5)

4
4
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81020
REMOVAL OF STOCk EXHAUST SySTEM
In these steps you will remove the stock exhaust system.
1. Use a sawzall to cut the exhaust immediately
behind the muffler.
2. Cut the exhaust on one of the Straight Pipes in
front of the muffler.
3. Use a Sawzall to cut the exhaust system at the bottom of
the Down Pipe.
4. To make removing the Hangers an
easier process, it is recommended that
you use a silicone spray lubricant to spray
each of the rubber hangers holding the
stock exhaust.
5. Remove each piece of the stock exhaust
system, including the stock exhaust
hangers. To remove the Down Pipe use a
7/16” deep socket to loosen the stock band
clamp. The stock band clamp will be used
on the new system.
1. Cut Exhaust Behind Muffler
2. Cut Straight Pipe in front of Muffler
3. Cut Exhaust at Bottom of Down Pipe
4. Remove Hangers
Band Clamps
7/16”
5. Loosen band Clamps