Bully Dog 81020 Rapid Flow - Manual (Page 6)

5
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81020
CLAMP AND HANGER PLACEMENT
Hanger A
Hanger B
Hanger D
4” Clamp
Clamps
Hanger C
QUICk OVERVIEw FULL EXHAUST
Muffler
24” Straight Pipe
Down Pipe
Tail Pipe Tip
Front Piece Tail Pipe
Adapter with Offset
40” Straight Pipe
In these steps you will install the Rapid Flow Exhaust System. Bully Dog’s Exhaust Systems are one-
cut systems, meaning that you should only have to cut one pipe or less if installed correctly.
1. It is suggested that before installing the system on the truck, the Rapid Flow Exhaust System be laid out on a large flat
surface to acknowledge the location of each piece.
INSTALLATION OF THE BULLy DOG RAPID FLOw EXHAUST SySTEM
Tool s Needed:
Silicone Spray Lubricant •
9/16” Wrench •
7/16” Deep Socket •
Socket Wrench •
Tape Measure •